Before you pay for a Saxonia Automatic super clone with a leather strap, confirm four things in writing: the real case diameter and thickness in millimeters, photos of the exact unit you will receive, the movement inside (named clone caliber or a known Swiss or Japanese base), and the strap specification. A credible super clone at this tier should track the genuine Saxonia Automatic footprint closely, roughly 38.5 mm across and about 9.5 to 10 mm thick, on a 20 mm lug width. If a seller cannot answer those four points with specifics, you are looking at a photo set rather than a watch.
what movement does the saxonia automatic replica use
What specs should a Saxonia Automatic super clone actually match?
The Saxonia is a quiet watch, so small errors read loudly. Measure the numbers against the reference before you commit.
- Case: ~38.5 mm diameter, 9.5 to 10 mm thick, 20 mm lugs, polished bezel with brushed flanks.
- Dial: applied baton markers, small seconds at 6, correct logo weight, no smudged printing under a loupe.
- Movement: automatic, 21,600 or 28,800 vph, 38 to 50 hours of power reserve, decorated rotor and bridges. A Miyota 9015 or ETA 2892 base outlasts most unbranded clones.
- Crystal: domed sapphire with anti-reflective coating on the inside only.
- Strap: 20 mm tapering to 18 mm, hand-stitched, with a tang or deployant buckle that matches the case metal.
How do you judge the leather strap before buying?
Ask for close-ups of the stitching, the lining, and the buckle engraving. Genuine-quality straps use edge paint that sits flat and even, saddle stitching that never crosses, and a soft lining that will not crack in a month. Cheap listings photograph the strap from one angle only because the underside is bonded leather.
best quality lange saxonia automatic copy
What is a fair price for a Saxonia Automatic super clone with leather strap?
Expect roughly $280 to $650 depending on movement and finishing, with documented Swiss-base builds landing at the top of that band. Below $150 you should assume mineral glass, a printed dial, and a corrected-hand sweep that stutters. Above $900 you are paying for a story, not a specification.
Which pitfalls sink most replica orders?
- Stock photos instead of QC images of your specific watch.
- "1:1 Swiss made" wording with no movement name attached.
- Gold plating described as solid or wrapped, which changes wear after months, not days.
- Water resistance claims with no pressure-test note. Treat any unverified rating as splash only.
- No stated return window or handling policy for customs seizures.
What should you check the moment it arrives?
Weigh the watch, time it over 24 hours against a reference clock, and inspect the dial printing under 10x magnification. Confirm the strap width at both ends with calipers and check that the crown screws or pushes cleanly with no grit. Photograph everything before wearing it, because that evidence is what gets a flawed unit replaced.